Configuring Loop Protection on AOS-Switch Ports

Loop protection provides protection against loops by transmitting loop protocol packets out of ports. For switches provisioned in UI groups, administrators can enable or disable loop protection on the switch ports or trunks by using the menu options available under Network Operations app, Manage> Device(s) > Switches.

Loop protection is always disabled by default on AOS-Switches. To configure loop protection for switches provisioned in the UI groups:

1. In the Network Operations app, select one of the following options:
   • To select a switch group in the filter:
     1. Set the filter to a group containing at least one switch.

        The dashboard context for the group is displayed.

     2. Under Manage, click Devices > Switches.
     3. Click the Config icon to view the switch configuration dashboard.
   • To select a switch in the filter:
     1. Set the filter to Global or a group containing at least one switch.
     2. Under Manage, click Devices > Switches.

        A list of switches is displayed in the List view.

     3. Click a switch under Device Name.

        The dashboard context for the switch is displayed.

     4. Under Manage, click Device.

        The tabs to configure the switch is displayed.

2. Click Interface > Loop Protection. The Loop Protection page is displayed.
3. Depending on whether you want to configure a port or trunk, complete one of the following steps:
   • In the Port Settings tab, select the port(s), click Edit.
   • In the Trunk Group Settings tab, select the trunk(s), click Edit.

Table 1: Viewing or Configuring Port Settings

Name	Description	Value
Port	The number assigned to the switch port.	0 – 65535
Loop Protection	Enables or disables loop protection.	Enable or Disable Default: Disable
Trunk Group	Name of the trunk group to which the port belongs.	Dependent on the switch type.

Table 2: Viewing or Configuring Trunk Settings

Name	Description	Value
Trunk Group	Name of the trunk group to which the port belongs.	Dependent on the switch type.
Loop Protection	Enables or disables loop protection.	Enable or Disable Default: Disable

4. Set loop protection to Enable in the Loop Protection drop-down.
5. Click OK.
6. Click Save Settings.